Page 103 - 2019 SHOP MANUAL CRF1000/A/D

dummyheadmmyhead
du

MAINTENANCE
BRAKE LIGHT SWITCH

The front brake light Adjust the brake light switch [1] so that the brake light
switch does not comes on just prior to the brake actually being
require adjustment. engaged.
If the light fails to come on, adjust the switch so that the
light comes on at the proper time.
Hold the switch body and turn the adjuster [2]. Do not [1]
turn the switch body.

[2]

BRAKE LOCK OPERATION (CRF1000D)

INSPECTION
Support the motorcycle using a safety stand or hoist
and raise the rear wheel off the ground. [1]
Unlock the parking brake lock lever [1] by pushing it
forward, then apply the parking brake lever [2]. Check
that the parking brake locked operation is properly.

[2]
ADJUSTMENT
Minor adjustment is made with the upper adjuster at the
parking brake lever. [1] [2]
Support the motorcycle using a safety stand or hoist
and raise the rear wheel off the ground.
Set the parking brake lever in one notch.
The adjuster may Loosen the lock nut [1] and turn the adjuster [2] until
be damaged if it is there is a slight drag while turning the rear wheel slowly.
positioned too far Tighten the lock nut while holding the adjuster.
out, leaving minimal
thread If the adjuster is threaded out near its limit and the
engagement. correct freeplay cannot be obtained, turn the adjuster all
the way in and back out one turn, then perform the
adjustment at major adjuster as follows.

Remove the parking brake caliper cover (page 19-10).
Set the parking brake lever in one notch.
Loosen the lock nut [1].
Turn the rear wheel slowly by hand and turn the push
rod [2] until there is a slight drag.
Hold the adjusting bolt and tighten the nut to the
specified torque.
TORQUE:17.2 N·m (1.8 kgf·m, 13 lbf·ft)
[2]
Recheck the parking brake operation.
Install the parking brake caliper cover (page 19-12).

[1]

3-21