Page 95 - 2019 SHOP MANUAL CRF1000/A/D

dummyheadmmyhead
du

MAINTENANCE
Check the oil filter boss [1] protrusion from the
crankcase is within the specified length as shown. Apply this area. 6.5 ± 1.0 mm
(0.26 ± 0.04 in)
SPECIFIED LENGTH: 15.5 – 16.5 mm (0.61 – 0.65 in)
[1]
• If the oil filter boss is removed, apply locking agent
to the oil filter boss threads as shown and install it.

15.5 – 16.5 mm
(0.61 – 0.65 in)
Clean the oil filter attaching surface of the crankcase.
Apply engine oil to new oil filter cartridge threads and
O-ring.
Install and tighten the oil filter cartridge [1] to the
specified torque using the special tool.
TOOL:
Oil filter wrench 07HAA-PJ70101

TORQUE:26 N·m (2.7 kgf·m, 19 lbf·ft)
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
[1]
CLUTCH OIL FILTER (CRF1000D)

• Replace the engine oil filter when the clutch oil filter
is replaced.
Drain the engine oil (page 3-12).
[5]
Remove the following:
– Bolts [1]
– Clutch oil filter cover [2]
– O-ring [3] [3]
–Spring [4]
– Clutch oil filter [5] [2]
Install a new clutch oil filter with the "OUT SIDE" mark [1]
[6] facing outside.
[6]
• Installing the oil filter backwards will result in severe
engine damage.
Apply engine oil to a new O-ring and install it to the oil
filter cover.
Install the spring and oil filter cover.
Tighten the bolts to the specified torque.
TORQUE:12 N·m (1.2 kgf·m, 9 lbf·ft)
[4]
Fill the crankcase with the recommended engine oil
check that there are no oil leaks (page 3-12).

3-13