Page 150 - 2019 SHOP MANUAL CRF1000/A/D

du
dummyheadmmyhead

PGM-FI SYSTEM
VS SENSOR

REMOVAL/INSTALLATION
Remove the battery box (page 21-6).
CRF1000D shown:
Disconnect the VS sensor 3P (Black) connector [1].
[2]
Remove the following:
– Bolt [2]
– VS sensor [3] [4]
– O-ring [4]
Installation is in the reverse order of removal.

• The VS sensor and outer mainshaft sensor are the
same parts.
• Replace the O-ring with a new one and coat it with
engine oil. [3] [1]
• Install the O-ring into the groove in the VS sensor.

O2 SENSOR

REMOVAL/INSTALLATION
Remove the exhaust pipe (page 2-17).
Remove the O2 sensor [1] using the special tool.
TOOL: [2]
Sensor socket wrench [2] FRXM17 (Snap on) [1]
or equivalent

• Handle the O2 sensor with care.
• Do not get grease, oil, or other materials in the O2
sensor air hole.
• Be careful not to damage the sensor wire.
• Do not use an impact wrench while removing or
installing the O2 sensor.
• Do not service the O2 sensor while it is hot.
Installation is in the reverse order of removal.
TORQUE:24.5 N·m (2.5 kgf·m, 18 lbf·ft)

BANK ANGLE SENSOR

REMOVAL/INSTALLATION
Remove the headlight (page 22-4).
[1]
Remove the nuts [1] and bank angle sensor [2].

[2]

4-42