Page 269 - 2019 SHOP MANUAL CRF1000/A/D

dummyheadmmyhead
du

CLUTCH/GEARSHIFT LINKAGE (CRF1000/A)
Apply locking agent to the set plate bolt threads (page
1-20). [3]

Install the set plate Install the set plate [1] and bolt [2] and tighten the bolt to [2]
with its punch mark the specified torque.
[3] facing out.
TORQUE:12 N·m (1.2 kgf·m, 9 lbf·ft)

[1]

Install the wire clip [1].
[2] [1]
Install the gearshift spindle cover [2] and bolts [3] and
tighten the bolts to the specified torque.
TORQUE:12 N·m (1.2 kgf·m, 9 lbf·ft) [3]
Route the wire harness properly (page 1-26).
Install the following:
– Clutch (page 12-12)
– Gearshift arm (page 12-21)

[3]
GEARSHIFT PEDAL

REMOVAL/INSTALLATION
Remove the pinch bolt [1] and gearshift arm [2] from the
gearshift spindle [3]. [1]
Remove the pivot bolt [4] and gearshift pedal [5]. Align
Remove the dust seals [6].
Check the dust seals and tie-rod ball joint dust cover for
deterioration or damage, replace them if necessary. [3]
Installation is in the reverse order of removal.

• Apply grease to the dust seal lips.
• Install the dust seals with the seal lip side facing out.
• Apply grease to the gearshift pedal pivot sliding area
(grease groove) of the pivot bolt.
• Align the slit of the gearshift arm with the punch [2]
mark on the spindle

[4]

[5] [6]

12-21