Page 425 - 2019 SHOP MANUAL CRF1000/A/D

dummyheadmmyhead
du

FRONT WHEEL/SUSPENSION/STEERING
WHEEL CENTER ADJUSTMENT
Place the rim [1] on a work bench.
Place the hub [2] in the center of the rim, and begin the [1]
lacing with new spokes.
Adjust the hub position so the distance from the hub left 28.5 – 30.5 mm
end surface to the side of the rim is 28.5 – 30.5 mm (1.12 – 1.20 in)
(1.12 – 1.20 in) as shown.

[2]

WHEEL BEARING REPLACEMENT
Replace the wheel Install the bearing remover head [1] into the bearing [2].
bearings in pairs. From the opposite side, install the bearing remover
Do not reuse old shaft [3] and drive the bearing out of the wheel hub.
bearings.
TOOLS:
Bearing remover head, 20 mm 07746-0050600
Bearing remover shaft 07746-0050100
Remove the distance collar and drive out the other
bearing.

[1] [2] [3]
Never install the old Drive in a new left bearing [1] squarely with the marked
bearings. Once the side facing up until fully seated.
bearings have been Install the distance collar.
removed, the
bearings must be Drive in a new right bearing squarely with the marked [2]
replaced with new side facing up until it is seated on the collar. [3]
ones.
TOOLS:
Driver [2] 07749-0010000
Attachment, 42 x 47 mm [3] 07746-0010300
Pilot, 20 mm [4] 07746-0040500

Replace the wheel bearings in pairs.
[1] [4]

17-13