Page 301 - 2019 SHOP MANUAL CRF1000/A/D

dummyheadmmyhead
du

DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
DTC 47-1 or 48-1 (No.1 or No.2
CLUTCH EOP SENSOR LOW
VOLTAGE)
1. Clutch EOP Sensor System Inspection
Connect the MCS and start the engine.
Check the clutch EOP sensor with the MCS.
Is about 0 V indicated?
YES – GO TO STEP 2.
NO – Intermittent failure
2. Clutch EOP Sensor Inspection
Stop the engine.
Disconnect the clutch EOP sensor 3P (No.1: Gray,
No.2: Black) connector (page 13-80).
Turn the ignition switch ON.
Check the clutch EOP sensor with the MCS.
Is about 0 V indicated?
YES – GO TO STEP 3.
NO – Faulty clutch EOP sensor
3. Clutch EOP Sensor Input Voltage Inspection
Measure the voltage between the wire harness side
3P connector [1].
Connection: Yellow/red (+) – Gray/black (–)
Is the voltage within 4.75 – 5.25 V?
YES – GO TO STEP 5.
NO – GO TO STEP 4.

G/Bl Y/R

[1]
4. Clutch EOP Sensor Input Line Open Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector (page [1] [2]
4-39).
Check for continuity between the wire harness side
3P connector [1] and 33P (Black) connector [2].
TOOL:
Test probe 07ZAJ-RDJA110
Connection: Yellow/red – B27
Y/R B27
Is there continuity?
YES – Replace the PCM with a known good one
(page 4-39) and recheck.
NO – Open circuit in the Yellow/red wire

13-31