Page 291 - 2019 SHOP MANUAL CRF1000/A/D

dummyheadmmyhead
du

DUAL CLUTCH TRANSMISSION (DCT) (CRF1000D)
4. Shift Spindle Angle Sensor System Inspection
Remove the shift spindle angle sensor with the
connector connected (page 13-79).
Turn the ignition switch ON.
While turning the shift spindle angle sensor shaft,
check the shift spindle angle sensor voltage with the
MCS.
When turning the shaft clockwise:
Voltage increase
When turning the shaft counterclockwise:
Voltage decrease
Does the voltage vary properly?
YES – GO TO STEP 5.
NO – Faulty shift spindle angle sensor
5. Shift Spindle Angle Sensor Condition Inspection
Check that the shift spindle angle sensor is installed
properly and is not damaged.
Is the shift spindle angle sensor in normal
condition?
YES – GO TO STEP 6.
NO – Install the shift spindle angle sensor
properly or replace it (page 13-79).
6. DTC Recheck
Recheck the DTC with the MCS.
Is DTC 22-1 indicated?
YES – Replace the PCM with a known good one
(page 4-39) and recheck.
NO – Intermittent failure

DTC 23-1 (SHIFT SPINDLE
OPERATION MALFUNCTION: WHILE
OPERATING GEARSHIFT
MECHANISM)
Refer to DTC 22-1 (page 13-20).

13-21